苏州洁明水处理技术有限公司 FLECK软水器原理
Principle of FLECK water softener
FLECK/pentair弗莱克全自动软水器就是将软水器运行及再生的每一个步骤实现自动控制，并采用时间，流 量或感应等方式来启动再生。
FLECK/pentair FLECK fully-automatic water softener is to run water softener and regeneration of each step to realize automatic control, and use time, flow quantity or induction methods such as to start the regeneration.
通常一个FLECK/pentair弗莱克全自动软水器的循环过程由以下几个具体步骤组成。
Usually a FLECK/pentair flack fully-automatic water softener cycle co 树脂中所含的可交换离子Na+，与水中的阳离子(Ca2+，Mg2+，Fe2+，…等)进行离子交换，使容器出水的Ca2+，Mg2+含量达到我们的要求。
Resin in the Na + exchangeable ions, and the cation in the water (Ca2 +, magnesium 2 +, Fe2 +,... etc.) for ion exchange, which makes water Ca2 +, magnesium 2 + co 这样，交换器的水流阻力不会越来越大。
In this way, the flow resistance of a switch will not bigger and bigger.
3、再生 再生液在一定浓度，流量下流经失效的树脂层，将树脂还原再生，使其恢复原有的交换能力。
3, renewable renewable liquid under certain concentration, flow through the failure of the resin layer, the resin regeneration, to restore its original exchange capacity.
4、置换 在再生液进完后，交换器膨胀空间及树脂层中还有尚未参与再生交换的盐液，为了充分利用这部分盐液，采用小于或相当于再生液流速的清水进行清洗，目的是不使清水与再生液产生混合。
4, after the replacement in the regenerative liquid into, switch to expand space and exchange resin layer and has not been involved in regeneration of salt solution, in order to make full use of this part of the salt solution, use less than or equal to renewable liquid flow rate of water washing, purpose is not to make water mixed with renewable liquid to produce.
5、正洗 目的是清除树脂层中残留的再生废液，通常以正常运行流速清洗至出水合格为止。
5, is to wash Purpose is to eliminate residual regeneration of waste liquid in the resin layer, usually by washing flow speed until the water qualified.
6、盐箱补水 向盐箱注入溶解再生所需盐耗量的水。
6, salt box filling water To dissolve salt box into regeneration needed salt co 3工作原理
Working principle of the 3
富来全自动软水器采用的是固定床钠离子交换软化法。
Rich to fully automatic water softener is fixed bed sodium ion exchange softening method is used.
固定床运行时，水流从上向下通过钠离子交换树脂层时，水中的钙、镁离子与树脂中的钠离子进行交换反应，使原水得到软化，树脂选用001×7强酸性苯乙烯阳离子交换树脂。
Fixed bed running, the water flow from the top down by sodium ion exchange resin layer, the water of calcium and magnesium ions with sodium ion exchange reaction of resin, the raw water softening, resin choose 001 x 7 stro 当钠离子交换树脂失效后，为了恢复其软化能力，用钠离子再生剂进行再生，既有顺流再生，也有逆流再生，再生剂一般采用食盐(NaCl)溶液。
When sodium ion exchange resin failure, in order to restore its ability to soften, regenerative agent with sodium ions regeneration, both the downstream regeneration, countercurrent regeneration, regeneration agent commo [1]
[1]
4FLECK软水器选型
4 fleck softener selection
M—流量型：制备水量达到设定值时自动还原，可适用于所有的给水系统软水制备。
M - flow type: the preparation of water reach setting automatic reduction, can be applied to all the water supply system of soft water preparation.
T—时间型：以时间为控制再生计量方式，适合用水量稳定的系统供水，最短还原再生周期24时。
T - type: time to time to co ◇ 4、可供选择的设备组合：
Left 4, selection of equipment combination:
⑴—单控单床：还原期间停止供水2小时或继续供原水(硬水旁通)。
: (1) - a single co ⑵—单控双床：交替供水，一用一备型。
2 - single co ⑶—双控双床：交替供水，一用一备型。
(3) - double with double bed: water alternately, use a case type.
⑷—双控双床：同时供水，交替再生。
(4) - double with double bed: water supply at the same time, alternating regeneration.
⑸—多控几床：三个以上树脂罐并联使用，适合大型供水系统。
5] - co 注：应根据所处理的原水硬度值选型。
Note: should be dealt with according to the raw water hardness value selection.
如属高硬度水(>8mmol/L时)，建议加大一级选型;
In the case of a high hardness water (> 8 tendency/L), suggest to primary selection;
>
>
12mmol/L时，应采用二次软化或配合其它方法.
Tendency of 12 L, seco 5FLECK软水器类型
5 fleck type softener
民用控制器
Civil controller
FLECK民用软水器主要有，5600型;
FLECK civil main water softener, 5600;
5000型，6700型这几款小型阀都属于民用水处理范围。
5000 type, 6700 type these a few small valve belong to civil scope of water treatment.
工业控制器
Industrial controller
FLECK工业软水器主要有，2750型;
FLECK industrial water softener, main type 2750;
2850型;
The type 2850;
3150型;
The type 3150;
2900型;
The type 2900;
3900型这几款大型阀都用于工业水处理范围。
The type 3900 these a few large scope of valves are used in industrial water treatment.
