苏州洁明水处理技术有限公司Before speaking JMA valve controller, we first said valve system more, perhaps there are a lot of people don"t know how what is valve system, let"s speaking, what is more valve system, JMA more valve co 我们常见的软水器分为两种:多路阀软水器和多阀系统软水器,其各自有着自己的优点和不足: 项目 多路阀系统 多阀系统 而多阀控制系统的优点则会显现出来: 控制器和阀门分离,易拆卸、维修更换方便 某个隔膜阀出现使用问题,只需拆除更换即可,甚至只需要更换阀门里面的膜片就可以了(我公司Y型隔膜阀出现故障时,只需要换膜片,阀体一般是不会坏的) 控制器出现电气故障,仍可手动事故运行 零部件互换性强 JMA多阀控制器分为很多种型号,每种型号则有不同的功能现在我们说下JMA502多阀控制器:
Our common water softener is divided into two kinds: multiple valve, water softener, water softener and valve system its each have their own advantages and disadvantages:
结构特点 多个可切换的通路,集成在同一个阀体 多个相互独立的阀门组成系统
通用性 专用阀门 标准通用阀门
控制及传动 控制部分与阀体集成一体 控制器与阀们之间以信号线相连
运行调节 固定选择 灵活多样,调节范围大
口径 小于DN80(3”) 没有限制
适用范围 小型民用与商用系统 流量小于20吨/时 工业系统,流量10吨/时以上
And the advantages of valve co
Co
A diaphragm valve use problems, o
There is an electrical fault controller, can still be run manually accident
Parts interchangeabilityMultiple valve system, therefore, is in big to
JMA valve co
JMA多阀控制器运行时分为四个状态:A运行-B反洗-C吸盐置换-D正洗
JMA valve co
注:用JMA多阀控制器的多阀系统中,隔膜阀一定要是常开式隔膜阀,如本公司的Y型隔膜阀
Note: use JMA much more valve valve co
JMA502多阀控制器参数:
JMA502 valve co
电源 : 220VAC/50HZ,10W功率
Power supply: 220 vac / 50 hz, 10 w power
分配器接口尺寸:1/8”G螺纹
G thread distributor interface sizes: 1/8"
控制源压力 :0.2~ 0.8MPa
Co
工作温度 :4~60 ℃
Working temperature: 4 ~ 60 ℃JMA502 valve co
复位运行——只要时间程序器处在工作位置,分配器就保证转回至工作位置;
Reset operation - processor in position to work as long as time, distributor will ensure that return to work location;
机壳防护等级 —— 防水、放电、防震;
Casing protection grade, waterproof, shockproof, discharge;Electrical source - 220 vac / 50 hz;
最多可调程序8个,设定时间10~9999秒,调整单位为1秒;
Eight most adjustable program, 10 ~ 9999 seconds, setting time adjustment unit to 1 second;
运行/再生状态灯光显示;
Run/regeneration status lights display;
有很多客户不知道如果选择JMA502多阀控制器和JMA505多阀控制器,下面来教大家一个简单的方法:
There are a lot of customers don"t know if choose JMA502 valve co
JMA502多阀控制器是用在顺流软化水设备上的,JMA505多阀控制器用在逆流软化水设备上.
JMA502 valve co
当盐水从罐子顶端进入时(5#阀在进水管上面)就用JMA502多阀控制器
When the salt water from the top of the pot into the (5 # valve in the feed line above) with JMA502 valve controllerWhen the brine from the tank bottom (5 # valve in the feed line below) with JMA505 valve controllerMany customers don"t know when buying a valve coJMA valve co
使用电压为220VAC,50/60HZ.通电前,测量电压应不高于250VAC.过高或波动太大时应加装稳压电源,同时有良好的接地保护,否则出现的损坏将不属于保修范围..
Using voltage is 220 vac, 50/60 hz. Before electricity, measure the voltage should be not higher than 250 vac. Too high or too much volatility should be equipped with regulated power supply, have good grounding protection at the same time, otherwise the damage will not belong to the warranty scope..